Configure an XTOUCH with an X32

To configure the X-Touch to control the X32 Rack mixer, follow these steps:

1. Connect the X-Touch and the X32 Rack to your network. (Assuming DHCP enabled on network)
2. Power up your x32
3. Under -"SETUP - REMOTE" make sure the "X-Touch over Ethernet" is check boxed
4. On the X-Touch, with it powered OFF, hold down "SETUP" button on input 1 and then turn on the unit.
5. On Fader 1, set the MODE in the screen to "XCTL"
6. On Fader 2, set the mode to "NETWORK"
7. On Fader 3, set the mode to "DHCP"
8. Wait...it SHOULD display an IP address after 5-10 seconds 
9. Select "SCAN" on fader 8.  (this will search for an x32 on the network)
10. In a couple of seconds your Xtouch should light right up with all the settings that are in the X32 reflected on its surface.